How To Install A Wick On A Kerosene Heater

How should I handle my new kerosene heater wick?
Spacer Line
Always allow the wick to soak completely before initial ignition. Soak the wick for at least lx minutes in the downward position in a full tank of fuel. Perform this soaking procedure for new wicks and someday a wick has burnt dry. Click here to purchase new kerosene heater wicks.

Problems occur if the wick is not fully saturated. Air pockets develop in the wick capillaries to block kerosene absorption. This brings the point of vaporization closer to the wick's surface, cooling rising vapors rather than burning them off. Tar/carbon volition begin to build upwards on the burner tube and wick, which decreases performance and causes smoke, odor, burning, and igniting bug. Click here for replacement kerosene heater wicks.

Why has my kerosene heater wick hardened over fourth dimension?

This is the aggregating of unburnt carbons and tar on the surface of the wick. This happens when the wick is at an improper top or adjustment, when the fuel has been contaminated (specifically with water), or if the heater has been operated at a lower than recommended setting. Click here for a selection of replacement kerosene heater wicks.

How often should I change my kerosene heater wick?

The American Lung Association, the U.S. Ecology Protection Bureau, and the U.Due south. Consumer Product Rubber Commission state, you should bank check and replace wicks yearly. Y'all should check and replace wicks more often if low quality fuel has been used or if the heater has been operated on a lower than recommended setting. Wicks with tar/carbon build upwardly, degraded wicks, wicks from concluding season, and improperly used wicks should all exist replaced for your safety. Click here for replacement kerosene heater wicks.

Cleaning a wick

If the wick has black tar deposits, information technology needs to exist cleaned or replaced. Wicks are best cleaned after a dry burning.Regularly remove carbon deposits with a castor or rummage. Avert using annihilation potent or hard, as this could damage the wick. Cotton wicks can be slightly trimmed (one/viii inch) for increased longevity. Do not do this with a fiberglass wicks, as this would damage the wick. If you wick is one-time, damaged, or degraded, buy a new wick. Do non store old wicks from previous seasons. Click here for a new kerosene heater wick.